To Next Page

To Previous Page

Manual 37365A GCP-30 Series Packages - Genset Control

Controller

≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡

WARNING

The following parameters dictate how the GCP-30 controls voltage, frequency, load, and power factor.

It is vital that the correct setting be entered in these parameters. Failure to do so may lead to incorrect

measurements and failures within the control unit resulting in damage to or destruction of the genera-

tor and/or personal injury or death.

NOTE

The parameters for this control are grouped together in blocks to permit navigation through the large

number of configuration screens more rapidly. Selecting "YES" or "NO" has no effect whether or not

control or monitoring is carried out for the parameters located in that block. Selecting "YES" or "NO"

only determines if the individual parameters may be accessed and changed or are bypassed.

Parameter 34

Configure

controller YES

Configuration of the controller YES/NO

The basic generator control functions are configured in this block of parameters.

This parameter has the following effects:

YES .............. The parameters in this block are displayed and can either be viewed

("Select" button), or modifications can be made to the parameters

("Cursor→", "Digit↑" or "Select" buttons).

NO ................ The parameters in this block are not displayed, cannot be modified,

and are skipped.

Woodward GCP-30 Series User Manual

Other manuals for Woodward GCP-30 Series