Manual 37365A GCP-30 Series Packages - Genset Control
© Woodward Page 7/179
Chapter 1.
General Information
Type English German
GCP-31/32 Series
GCP-31/32 Packages - Installation 37364 GR37364
GCP-31/32 Packages - Configuration this manual 37365 GR37365
GCP-31/32 - Function/Operation 37238 GR37238
GCP-31/32 - Application 37240 GR37240
GCP-31/RPQ - Installation 37366 GR37366
GCP-31/RPQ - Configuration 37367 GR37367
Option SB - Caterpillar CCM coupling 37200 GR37200
Option SC09/SC10 - CAN bus coupling 37382 GR37382
Additional Manuals
IKD 1 - Manual 37135 GR37135
Discrete expansion board with 8 discrete inputs and 8 relay outputs that can be coupled via the CAN bus to the control unit. As-
sessment of the discrete inputs as well as control of the relay outputs is done via the control unit.
LeoPC1 - Manual 37146 GR37146
PC program for visualization, configuration, remote control, data logging, language upload, alarm and user management and man-
agement of the event recorder. This manual describes the use of the program.
LeoPC1 - Manual 37164 GR37164
PC program for visualization, configuration, remote control, data logging, language upload, alarm and user management and man-
agement of the event recorder. This manual describes the programming of the program.
GW 4 - Manual 37133 GR37133
Gateway for transferring the CAN bus to any other interface or bus.
ST 3 - Manual 37112 GR37112
Control to govern the air fuel ratio of a gas engine. The ratio will be directly measured though a Lambda probe and controlled to a
configured value.
Table 1-1: Manual - Overview
To Next Page
Loading...
