EasyManua.ls Logo

Woodway PATH - Cleaning and Maintenance; Cleaning Procedures & Intervals

Woodway PATH
136 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
118 03/2016 UM-MT-EN-01
9 Cleaning and Maintenance
WARNING
Danger of Injury due to Lack of Qualifications!
If maintenance or repairs are not carried out by professionally qualified per-
sonnel, serious injury and material damage may occur.
Maintenance and repair work may only be performed by qualified person-
nel.
It is the sole responsibility of the representative to assign qualified person-
nel for maintenance and repair work.
Clean and examine the machine regularly for damage and/or wear, paying
special attention to areas susceptible to wear.
In case of doubt or questions, always contact WOODWAY Customer Ser-
vice or your dealer.
The manufacturer is not liable for personal injury and material damage
caused by a lack of qualifications!
9.1 Cleaning
Periodic cleaning and inspection of your WOODWAY treadmill will help lengthen its life
while keeping it looking like new. With this preventative maintenance it will be easier to
identify possible issues that might otherwise be overlooked.
Below is a guideline of recommended cleaning and maintenance intervals.
DANGER
Danger of Death by Electric Shock!
The use of water and liquid detergents as part of cleaning can cause serious
or fatal electrical shock.
No liquids may come in contact with electrical parts such as motor, power
cord, power switch, and control monitors.
Do not spray the device with a water jet.
Pull power plug before cleaning; equipment must not be connected to
power! Ensure the device cannot be switched back on.
The running surface should be thoroughly cleaned at regular intervals, depending on the
intensity of use.
Remove light dirt and dust with a soft cloth. Dirt can be removed with damp cloth and
mild soapy water. After cleaning dry with a dry cloth!
Cleaning Notes
Do not use abrasive brushes or abrasive cleaners, as the paint and plastic surfaces
can be scratched.
Do not use sharp tools (e.g. knife, metal scraper) or aggressive cleaning solvents
for cleaning.
Clean all surfaces with a mild, non-abrasive detergent (eg.
409
or
Fantastic,
diluted
with water to 50/50).
To avoid damage to component surfaces, observe the instructions for detergent
use.
For cleaning and disinfection of parts that are touched (handrail, display, con-
trols, etc.) a formaldehyde-free rapid disinfectant such as "Bacillol plus" or "Des-
cosept" is recommended.

Table of Contents

Other manuals for Woodway PATH

Related product manuals