Woodway PATH - Maintenance Intervals

03/2016 – UM-MT-EN-01 119
9.2 Maintenance Intervals
DANGER
Danger of Death by Electric Shock!
Maintenance and inspection work on the unit may cause serious or fatal elec-
trical shock.
► Pull the power plug prior to any maintenance and inspection work on the
equipment. The device must not be connected to the power.
► Ensure the device cannot be switched back on.
Weekly Maintenance
 Clean handrails, display, and side covers with a damp cloth.
 Disinfect railings and controls.
 Clean the running surface with a damp, lint-free cloth.
 Visually check the power cord for damage.
 Check the treadmill for mechanical damage.
 Check mounting of all controls (display, emergency stop mushroom, side panels)
 Clean the area under the treadmill (vacuum and mop).
CAUTION
Worn or damaged components must be replaced immediately. If the observed
deficiency can cause danger to the user or operator of the treadmill, it needs
to be taken out of service until repaired.
Monthly Maintenance
A complete function test of the treadmill must be carried out every 2 - 4 weeks depend-
ing on the duration and intensity of use.
The function test includes the following:
1.
Use the treadmill for a short time at speed of 3.5 - 6 MPH (6 - 10 km/h).
Do unusual noises occur?
2.
Turn up treadmill to max. speed for a short time. Does the treadmill reach
the specified max. speed? Do unusual noises occur?
3.
Does the display correctly show the distance traveled at top speed?
4.
Stop the treadmill and move it to max. incline. Does the treadmill reach
the desired incline?
5.
Do unusual noises occur while the treadmill is running at max. incline?
6.
Check the emergency stop magnetic switch function. Is an emergency stop
initiated?
7.
Check the function of the emergency stop mushroom and/or button.
8.
Set the treadmill to STAND-BY mode. Though slight movement is normal,
the running surface must be very difficult to move. Is the running surface
stopped correctly?