52 03/2016 – UM-MT-EN-01
16. Position the side covers so
that a ¼ in. (5 mm) gap is
visible.
17. Then tighten all screws.
Note:
The side covers
must not be in contact with
the running surface or drive
belts on the rear left side!
Fig. 36 Desmo assembly, adjusting side covers
6.4.4 ELG
Please contact your local representative for ELG assembly assistance.
6.4.5 Mercury, Path
Tools required for assembly:
1x combination wrench or ratchet wrench, ½”
1x Phillips head screwdriver, #2
1. Remove the cover plates
and side covers on both
sides.
Fig. 37 Mercury/Path assembly, side covers
2. Insert wire and protective
cover into the guard rail
tube to prevent damage
during insertion.
Fig. 38 Mercury/Path assembly, wiring
To Next Page
Loading...
