34 03/2016 – UM-MT-EN-01
4 Transportation and Storage
4.1 Safety Notices for Transportation
Check the treadmill for damage upon arrival. Also check and compare supplied accesso-
ries with the corresponding delivery note.
The manufacturer is not liable for damages and missing parts if this information was not
recorded in writing on the delivery note upon delivery of the unit. Damage or defects
must be reported to the carrier and to the responsible WOODWAY dealer immediately.
Risk of Injury by Machine Falling or Falling Over!
Improper transportation of the device may lead to it falling over and causing
injury or equipment damage.
► Only transport in compliance with the safety regulations.
► Only use the supplied carrying tubes for transport.
► Never lift the device using the railing or protective coverings.
► Ensure stable center of gravity and steadiness during transportation.
If necessary, transport or relocation can be organized and carried out by authorized
WOODWAY service partners.
For further information please contact WOODWAY Customer Service.
4.2 Flat Transportation
The treadmill can be easily transported on a flat surface using four flat transport dollies
(commercial transport dollies with 4 steerable wheels). The device weight must be con-
sidered.
It is important to ensure that the device frame near the treadmill feet rests on the dol-
lies. Otherwise, there is a risk of damage to the walking surface or the incline system.
4.3 Upright Transportation
For narrow transport routes it is possible to transport the treadmill vertically (e.g. narrow
door width or for climbing stairs). For this, handrails and side panels must be removed.
When transporting in an upright position, the device must be additionally secured
against accidental tipping or rolling since the center of gravity is not in the middle of the
device.
The treadmill must not rest on the side on which the power cord is connected!
4.4 Transportation with Carrying Poles
Four carrying poles (square steel pipes) are included as treadmill accessories. The carry-
ing poles can be inserted into the front and back openings in the treadmill frame (Fig. 10
and Fig. 11). The side panels and railings can be removed to facilitate transport.
To Next Page
Loading...
