03/2016 – UM-MT-EN-01 37
5.3 Incline System
WOODWAY treadmills are equipped with a standard elevation system which is model
specific. The elevation system is driven by a geared motor and a chain drive system
which is used to transmit forces to several drive sprockets. This gear drive raises or low-
ers the treadmill on toothed racks. The toothed racks are equipped with rubber feet and
bear most of the weight of the treadmill and the person when the incline is used.
Limit switches are used to limit the lifting system. When the display is switched on, the
running surface is automatically moved to the 0 incline position (starting position).
Danger of Device Moving Down when Switched on!
If the treadmill was in the inclined position prior to being switched off dur-
ing previous use, the device will automatically move back to the neutral
position (0% incline). There is a danger of injury!
► No one may be located in the area in front of the treadmill.
► No objects may be located under the treadmill.
► Check the position of the treadmill before switching it on.
5.4 Dynamic Mode
Do Not Leave Treadmill Unattended While in Dynamic Mode!
If the treadmill is left unattended while in dynamic mode, there is a possi-
bility of personal injury from people stepping onto device while assuming
the running surface is locked.
► Never leave the treadmill unattended while in dynamic mode.
► The running surface runs completely free in both directions and is no
longer slowed by the motor.
► Always keep children and animals clear of the treadmill while in dynam-
ic mode.
The treadmill makes it possible that the user serves as the running surface belt drive.
The user drives the running surface belt manually during training. This is known as "dy-
namic mode"
5.4.1 Dynamic Mode: LED Standard Display Board
To enter dynamic mode, proceed as follows:
1. Reduce both SPEED and INCLINE to zero and step onto side rails.
2. Press and hold the FAST and SLOW keys simultaneously for about 5 seconds.
3. The display emits a signal tone every second.
4. Afterwards, 2 tones will sound and the speed indicator display will start blinking.
Now the treadmill is set to dynamic mode. The running surface belt is now manually
driven and the speed is still indicated. The incline also functions.
To leave dynamic mode, proceed as follows.
1. Reduce INCLINE to zero and step onto side rails.
2. Press and hold the FAST and SLOW keys simultaneously for about 5 seconds.
3. The display emits a signal tone every second.
4. Afterwards, 2 tones will sound and the speed indicator display will stop blinking.
Dynamic mode is now deactivated. The running surface belt is now motor driven.
To Next Page
Loading...
