Woodway PATH - Options and Accessories; Power Input, Handrail Controls, Reverse Mode

108 03/2016 – UM-MT-EN-01
8 Options and Accessories
8.1 Power Input 208 / 230 V
The 208/230 VAC input voltage requirements are options for all WOODWAY treadmills.
An input power transformer for 208/230 VAC has been installed and connected. This
does not affect the other parts of the treadmill.
8.2 Handrail Controls
(Not available on PATH)
One of the unique features of WOODWAY treadmills is the side controls on the railing.
By using the controls on the railing the user can adjust the speed and/or incline without
leaning over the display, allowing the user to continue running and minimizing the risk of
losing the balance and/or falling.
The control panel on the railing consists of five keys: STOP, SPEED INCREASE, SPEED
DECREASE, INCLINE UP, and INCLINE DOWN.
8.3 Reverse Mode (Bi-Directional Belt Control)
WARNING
Do Not Leave Treadmill Unattended While in Reverse Mode!
If the treadmill is left unattended while in reverse mode, there is a possi-
bility of personal injury from users stepping onto device while assuming
the running surface will move normally.
► Never leave the treadmill unattended while in reverse mode.
► Always use supervision while training in reverse mode.
► Keep children and animals clear of the treadmill while it is in reverse
mode.
The bi-directional belt control feature is an option for some of our models. This option
will only be activated if it was selected upon purchase.
The incline system is not affected by this option. In the reverse direction, speed is lim-
ited to approx. 5 MPH (8 km/h) for safety reasons. Constant supervision is required
while the treadmill is in reverse.
1. Hold down the SLOW button for 5 seconds while speed is set to 0 MPH (km/h).
2. The display will beep 3 times to let the user know reverse mode is in effect.
 While in reverse mode, the SPEED will be displayed as a negative value
(e.g. -2.3 MPH)
 If on an LCD Personal Trainer Display Board, the LCD display will read “Reverse
Mode”
3. To exit reverse mode, hold the SLOW button for 5 seconds while the speed is at
0 MPH (km/h). The display will beep 3 times to let the user know that forward mode
has been restored.