03/2016 – UM-MT-EN-01 69
7.7.1 Display Parameters
Manual speed and incline control
Quickset speed and incline control
Statistics display: distance, calories, time, pace, heart rate, and METs
Treadmill SPEED and INCLINE display
Controlled increase/decrease of speed, safety checks, and automatic shut-off in
case of errors
7.7.2 Training Parameters
Press the FAST key to start training. The speed increases from "0". The time LED is lit
and the time is displayed and counted in the TIME display in the 00:00 format. The
DISTANCE and HEART RATE LEDs are lit and the corresponding values are displayed.
During training the user can change the incline using the UP/DOWN incline keys, and the
speed using the FAST/SLOW speed keys. The user can interrupt the training at any time
using the PAUSE key.
During training, the user can use the quickset speed and incline control keys to more
quickly change the speed or incline to the desired level. To set the speed or incline to a
value between those available using quickset keys, select the nearest quickset value key
and then use the manual controls as described above to adjust to the desired value.
When the user presses the PAUSE key, the treadmill stops. The TIME display indicates
"PAUSE" and the other 7-part displays maintain the values from the time that the PAUSE
key was pressed. To begin training again, the user can press the PAUSE key again. The
speed is increased to the former value and the TIME display starts counting the time.
During training, the user can press the “PACE, CALORIES, METS” key to change between
the values for the distance, time, and heart rate. The distance is replaced by calories,
the time is replaced by pace, and the heart rate is replaced by METS. When the PACE,
CALORIES, METS key is pressed again, the displays show the original values again. The
LEDs for the respective statistics are lit.
The user can press the OFF key at any time to end the training session. Speed and
incline are reset to zero. The training statistics are displayed for 10 seconds. The time
display shows the total time and the DISTANCE/CALORIES display shows the total dis-
tance and total calories burned alternately.
The STOP key on the side switches corresponds to the OFF key on the screen.
To Next Page
Loading...
