03/2016 – UM-MT-EN-01 79
The time is counted down to zero, and then speed and incline will be set to the first
segment values. Distance and calories are accumulated. The program profile is shown
on the LCD display. The number keys, CLEAR key, and ENTER key are now deactivated.
While the program is running the user can change the incline using the UP/DOWN incline
keys, and the speed using the FAST/SLOW speed keys. The user can interrupt the
training at any time by pressing the PAUSE key. The status of the selected program
lights up to show progress. The signal sounds 3 seconds before the speed and/or incline
changes.
When the PAUSE key is pressed, the treadmill stops. The following information is shown
on the LCD display: "Treadmill Paused. Press PAUSE to resume.” The statistics are
paused when the PAUSE key is pressed. When the user presses the PAUSE key again,
the workout resumes. The CLEAR key is activated during the pause. Pressing the CLEAR
key will reset all the treadmill statistics and return the user to the opening screen (the
LCD display shows the message "Press 'FAST' for Quick Start or select a program").
The statistics are displayed at the bottom of the screen throughout training. Here infor-
mation such as PACE, CALORIES, CALORIES/HR, VERTICAL FEET, and METs can be
found.
When the program is completed, the LCD will read "Program Complete" and the SPEED
is then reset to zero.
When the OFF key is pressed, speed and incline reset to zero and the display will then
switch off.
The heart rate control (incline and speed) program functions as follows, following the
above algorithms:
The speed is increased in increments until 80% of the user's maximum speed is
reached (calculation based on user training level input).
The incline is increased in increments until 10% of the maximum treadmill incline is
reached.
The speed is increased in increments until the user's maximum speed is reached.
The incline is increased until the maximum treadmill incline is reached.
Displaying the
Statistics
To Next Page
Loading...
