Multi 3620 IDS Commissioning
ba77169e01 04/2016 14
During mains operation, one of the following symbols is displayed:
3.3.3 Switching on the meter
CAUTION
The batteries in the battery compartment are automatically
charged when the power pack is connected.
Make sure that only NiMH rechargeable batteries are in the
battery compartment. The charging process is optimized for
NiMH batteries. Other battery types can cause damage during
the charging process.
Make sure that the ambient temperature is not more than 40 °C
(104 °F) when the power pack is connected.
1 Connect the plug of the power pack to the socket for the power pack
on the Multi 3620 IDS.
2 Connect the original power pack to an easily accessible power outlet.
:
Mains operation with charge function
Batteries are automatically charged in the background.
:
Mains operation
Charge the batteries completely prior to putting the meter into oper-
ation for the first time. The charging process takes approx. 10
hours. The symbol is displayed if the batteries are nearly dis-
charged.
1 Press the <On/Off>
key.
The meter performs a self-test.
The display shows the manufacturer's logo while the self-test is being
performed.
2 Connect the sensor.
The meter switches to the measuring mode (measured value display).
The meter has an energy saving feature to avoid unnecessary
power consumption during battery operation.
The energy saving feature switches off the meter during battery
operation if no key is pressed during the adjusted interval. (How to
set the switch-off interval, see section 11.6).
The switch-off interval of the energy saving feature is not active
when the meter is supplied with power via the power pack or the
USB-B cable.
To Next Page
Loading...
Need help?
General
