To Next Page

To Previous Page

Multi 3620 IDS Settings

ba77169e01 04/2016 80

After the specified calibration interval has expired, the sensor symbol or the

QSC color scale flashes. It is still possible to measure.

Setting the

calibration interval

The calibration interval is set to 7 days (d7) in the factory.

You can change the interval (1 ... 999 days):

11.2 ORP measurement settings

11.2.1 Settings for ORP measurements

The settings are made in the menu for measurement settings of the ORP mea-

surement. To open the settings, display the required measured parameter in

the measured value display and press the <ENTER> key. After completing the

settings, switch to the measured value display with <M>.

Default settings are printed in bold.

11.3 D.O. measurement settings

11.3.1 Settings for D.O. sensors

The settings are available in the menu for measurement and calibration set-

tings. To open the settings, display the required measured parameter in the

measured value display and press the <ENTER> key. After completing the set-

tings, switch to the measured value display with <M>.

To ensure the high measuring accuracy of the measuring system,

calibrate after the calibration interval has expired.

1 Open the menu for measurement settings with <ENTER>.

2In the Calibration / Calibration interval menu, set the calibration interval

with <><>.

3 Confirm the setting with <ENTER>.

4 Quit the menu with <M>.

Menu item Possible set-

ting

Explanation

mV resolution 0.1

Resolution of the mV display

Reset - Resets all sensor settings to the

delivery condition (see section

11.7.1).

wtw Multi 3620 IDS User Manual

Questions and Answers: