wtw Multi 3620 IDS - Resetting the System Settings

Multi 3620 IDS Settings
ba77169e01 04/2016 90
The sensor settings are reset under the Reset menu item in the menu for cali-
bration and measurement settings. To open the settings, display the required
measured parameter in the measured value display and press the <ENTER>
key.
11.7.2 Resetting the system settings
The following system settings can be reset to the default status:
The resetting of the system settings is done in the menu Storage & config / Sys-
tem / Reset. To open the menu Storage & config in the measured value display,
press the <ENTER_> key.
Setting Default settings
Kal.-Intervall 30 d
Measured parameter FNU
Auflösung 0.1
Setting Default settings
Language English
Acoustic signal on
Volume 6
Baud rate 4800 Baud
Output format ASCII
Decimal separator .
Brightness 15
Illumination Auto
Switchoff time 1 h
Temperature unit °C
USB Host on
Stability control on