wtw OxiTop C - Excluding a Curve (BOD Standard Operating Mode)

Operating mode: BOD Standard / BOD Routine OxiTop
®
Control OC 100
32 ba31114e06 06/2012
5.5.2 Excluding a curve (BOD Standard operating mode)
This function is used to temporarily exclude a single curve (e.g. an outlier) from
the evaluation and averaging of an overall sample.
The function "List of measuring heads“ (see section 5.4 SAMPLE STATUS
TYPE
LIST (SAMPLE MANAGEMENT), page 24) is used to find leaky or defective
single samples.
Changes to sample statistics.
The menu selection shown here
only appears if the number of
measuring heads (n) is at least
2.
If n = 1 pressing of
<RUN/ENTER>
changes
directly to the cursor interroga-
tion.
When jumping to the selection menu from “Show all curves“, the
menu item - Exclude curve is not displayed.
Results of the finished sam-
ple:
Data of the current sample:
 Mean value
 SD: standard deviation
(from n = 3)
 n: number of measuring
heads
<PRINT>
Printout of the results with
curves
 end date
 current mean value
 n: number of measuring
heads
<PRINT>
Printout of the data (current
mean value, n, sample
information) with curve paths
to date
The curve is only excluded temporarily! The data stock of the
SAMPLE STATUS TYPE list (sample management) does not
change. The excluded curve is present again when the call is
repeated.
RUN/ENTER
RUN/ENTER