GLP/TOOLS OxiTop
®
Control OC 100
38 ba31114e06 06/2012
7 GLP/TOOLS
7.1 GLP/TOOLS main menu
GLP/TOOLS menu:
Use <><> to select a submenu.
Confirm with <RUN/ENTER>.
The selected menu opens up or the function is
carried out.
GLP/TOOLS menu:
- Show free
This function is used to identify free measuring heads. Thus an additional
sample labeling is not required. Free measuring heads can be used to start
new samples.
- Show Settings The current settings are displayed here.
- Settings Here you can undertake or change the following settings:
- Operation mode
- Measuring time
- date/time
-GLP; calibration interval (not in the BOD Routine operating mode)
- Memory erase!
- AutoTemp (BOD Standard operating mode)
- Switch-off interv.(not in the BOD Routine operating mode)
- Temperature- Height- Air pressure- Limit pressure- Language
- Check - Show (finished/all)
- info (with report printout)
- Controller Info (with report printout)
-Cal Test
- Pneumatic test
- Maintenance - Erase sample
(in the controller - SAMPLE STATUS TYPE list (sample management))
- Reset/release
- Restore data
To Next Page
Loading...
