wtw OxiTop C - Changing the Supply Battery (Measuring Head)

OxiTop
®
Control OC 100 Maintenance, cleaning, disposal
ba31114e06 06/2012 65
9.1.4 Changing the supply battery (measuring head)
 Change the battery after the measurement has been terminated.
 Press in the snap-action holder and open the upper case.
 Remove the batteries.
 Insert new batteries (2 x lithium batteries, CR2430, e.g. WTW type Batt/Oxi-
Top
®
). When doing so make sure the batteries are inserted in the correct
position!
 Insert the upper case with the lug in the locking pin (lower case).
Caution! Do not crush the cable connection!
 Close the upper case (let the hook snap into place).
Check if the battery change was successful:
In the GLP/TOOLS - Check -  info menu, Batteries: OK must appear.
The batteries do not affect the data integrity of the OxiTop
®
-C
Dispose of used batteries according to the local regulations of your
country.
End users within the European Union are obligated to return used
batteries (even ecologically compatible ones) to a collection point
set up for recycling purposes.
Batteries are marked with the crossed-out waste container symbol.
Therefore, they may not be disposed with the domestic waste.