Xerox 6204 Wide Format Solution Participant Guide
15
6 Setting Up the Original Size Series & the Media Type
The controller needs to know both the size of the original being
scanned and the type, size, and thickness of the roll media in the
media drawer(s). It uses this information to perform a number of
important tasks, among them reduction and enlargement, matching
media and document sizes, and selecting the best fusing
temperature and Xerographics settings.
If you always scan the same size originals or run the same size,
type, and thickness roll media, it is not necessary to change the
Original Size Series or the Media Settings after they’re set up.
If you copy various size series originals, the Original Size Series
must be set up every time you scan an original of a different series.
If you use a variety of media, the Media Settings must be changed
every time a different roll is loaded. Error messages and incorrect
image placement on the media will result if this step is skipped.
Objectives
When you complete this section you will be able to:
• Correctly access the Original Size Series and Media Settings
on the Control Panel.
• Specify on the Control Panel the size series of the originals
used throughout this Participant Guide.
• Specify on the Control Panel the type, thickness, and size of
the roll media which is loaded in the media drawers.
Reading Activity
Read the following sections in the User Guide after loading media
and before running a copy, scan, or print job.
2 Product Overview:
Size Series Settings for Originals
Media Settings
Resources Required
None
To Next Page
Loading...
Need help?
General
