Xerox 6204 Wide Format Solution Participant Guide
41
3. Select any one of the directional buttons, and then press Save.
4. Insert the 8.5” x 11” graphic document into the scanner, LEF,
and make one copy. The image will shift in the direction that
you selected.
5. Press Clear All.
Activity 2 – Margins (Border Erase)
In this activity you will use the Margins feature to remove the border
that is present at the outer edge of the original from the copies.
Refer to 3 Copy – Margins in the User Guide as you perform the
steps below:
1. Press the Original/Media Size Settings button on the Control
Panel. The [Original Size Series] and [Media Settings] tabs will
display.
2. Press the ARCH-1 button on the Original Size Series tab.
3. Press the Close button.
4. Set up the job as follows:
R/E: 100%
Media Source: Select the 18” roll paper
Media Type: Not applicable
Output Format: Synchronized
Copy Quantity: 1
Original Type: Text/Line
5. Select the [More Features] tab on the Touch Screen.
6. Press the Margins button.
7. In each entry field, enter a value that will erase the black
border. Start by entering 15mm.
8. Press Save.
9. Insert the original in the scanner and make a copy.
10. Check the copy. If the border is completely erased, press Clear
All and go to the next activity; if not, go to step 11.
11. If the border is not completely erased, increase the Margins
values and make another copy.
12. Press Clear All after you produce a copy that has the border
entirely erased.
To Next Page
Loading...
Need help?
General
