Xerox 6204 Wide Format Solution Participant Guide
43
Activity 4 – Scan Offset
The Scan Offset feature enables you to eliminate unwanted image
detail at the lead edge of a document from the copy. The scan start
position is the point after the document begins to feed where the
machine begins to collect image information (scan the document).
Delaying the start of scanning prevents unwanted image detail from
being included on the copy.
Refer to 3 Copy – Scan Offset in the User Guide as you perform
the steps below:
1. Make the following selections on the Touch Screen:
R/E: 100%
Media Source: Select the 18” roll paper
Media Type: Not applicable
Output Format: Synchronized
Copy Quantity: 1
Original Type: Text/Line
2. Press the [More Features] tab.
3. Press the 3 at the lower right corner to display the Scan Offset
button.
4. Press the Scan Offset button.
5. When the [Scan Offset] screen displays, select Enabled.
6. Using the scroll buttons, enter a value of 0.5 inch.
7. Press Save after 0.5 inch appears in the entry field.
8. Feed the document into the scanner to make a copy.
9. Check the copy. The first 0.5 inch of the lead edge of the copy
should be blank.
10. Press Clear All.
To Next Page
Loading...
Need help?
General
