Xerox 6204 Wide Format Solution Participant Guide
31
12 Making Manual Feed Copies
Objectives
Upon completion of this module, you will be able to:
• Set up and run a copy using the Manual Feed Tray (Bypass
Feeder)
Reading Activity
Read the following section in the User Guide before setting up and
running the copy.
3 Copy:
Making Copies using the Manual Feed Tray (Bypass)
Resources Required
Two sheets of 12” x 18” (B/A3) 20 pound bond paper
One 12” x 18” original
Manual Feed Activity
In this activity you will make two copies using the Manual Feed Tray
as the media source.
Refer to 3 Copy – Making Copies using the Manual Feed Tray
(Bypass) in the User Guide as you perform the activity.
1. On the [Basic Copy] tab, press the Sheet button under the
Media Source heading.
2. Press the <Original/Media Settings> button on the Control
Panel.
3. Select the [Media Settings] tab.
4. Under the Size Series heading, select the Manual button.
5. On the [Manual Size Series] screen, select the button beside
the ARCH-1 settings (36”, 24”, etc.), and then press Save.
6. Under the Type Thick. Heading, select the Manual button.
7. On the [Manual Media Type/Thickness] screen, select Bond
and Ordinary, then select Save.
8. Press the Close button on the [Media Settings] tab to return to
the [Copy] screen.
9. Leave the R/E setting at 100%.
10. Although you can copy just one sheet at a time using the
Manual Feed Tray, set the Quantity to 2 using the numeric
keypad.
To Next Page
Loading...
Need help?
General
