Xerox 7142 - Page 112

4 Parts Replacement RJ-901C/RJ-900C Maintenance Manual
4-66
(1) Preparation of Replacing Ink Tube
1. Perform ink discharge operation to discharge ink entirely from the ink paths.
2. Remove the tube clamps (3 points).
3. Remove the tube film guide retainers (3 points).
4. Remove the CR board cover.
Up to step 4 in "4.6.1 Replacing Print Head" p.4-37
5. Remove the CR tape wire from the CR board.
No. Part name
1 Tube guide
2
Tube clamp
No. Part name
1 Tube guide
2
Tube film guide retainer
2
1
2
1