RJ-901C/RJ-900C Maintenance Manual 9 Troubleshooting
9-75
9.3.7 Other Problems
5 Media feed after
printout is excessive.
1. Are print start position
and layout method set
properly?
Check the media type setting. Operation
Manual
2. Plotter driver setting
may be unsuitable.
• Modify the value to an
appropriate value(Media
size).
• Update plotter driver.
Operation
Manual
3. Program ROM may be
defective.
Update firmware. "7.3.5
Firmware
Installation"
p.7-15
4. Main board assembly
may be damaged.
Replace main board
assembly.
"4.3.3
Replacing
Main Board
Assembly"
p.4-21
Table 9-15 Symptoms, Check Items, and Actions
No. Event/symptom Check item Action Reference
1 Machine hangs up. 1. Internal process of
main board assembly
may be abnormal.
Initialize parameters and
reenter or modify them.
"7.3.1
Parameter
Backup" p.7-
10
2. Main board assembly
may be damaged.
Replace main board
assembly.
"4.3.3
Replacing
Main Board
Assembly"
p.4-21
Table 9-14 Symptoms, Check Items, and Actions for Online Function Problems(Continued)
No. Event/symptom Check item Action Reference
To Next Page
Loading...
