RJ-901C/RJ-900C Maintenance Manual 7 Adjustment
7-19
7.3.6 Sending Parameters
NOTE
Before sending parameters, perform the following work.
• Receiving parameters: "7.3.4 Receiving Parameters" p.7-14
• Firmware installation: "7.3.5 Firmware Installation" p.7-15
1. Click [Parameter Send].
2. When the "Select of send parameter file" window
opens, select the parameter file to be transferred
and click [Open].
3. In the "Parameter Send check" window, click
[OK].
Sending will start.
4. When sending completes and the "Send
completed" window opens, click [OK].
To Next Page
Loading...
