Xerox Phaser 6128MFP - Enabling the Printer for Scanning

Initial Setup at the Control Panel
Phaser® 6128MFP Multifunction Printer
30
Enabling the Printer for Scanning
The printer is enabled for scanning (if you are connected to a network), but you can not
scan until scanning is set up in CentreWare IS.
If you are connected via USB, you can scan to a folder on your computer, or scan into an
application after you have installed the scan drivers and the Express Scan Manager utility.
Note: If you are connected via USB, you can not scan to an email address or a network
location (a shared folder on your computer).
For more information see Scanning Setup Overview on page 37.