Xerox VersaLink Series User Manual

USB
The printer provides multiple USB ports. The exact number varies, depending on the printer model. All
models have the following two USB ports:
• One host port on the front of the printer
• One target port on the back of the printer
In the Embedded Web Server, the USB configuration window provides two toggle buttons for
enabling USB:
• Enable: This toggle button enables and disables all the USB ports at the same time.
• USB Port: This toggle button enables and disables only the target port on the back of the printer.
To configure USB:
1. In the Embedded Web Server, log in as administrator, then click Connectivity.
2. In the Connections area, click USB.
3. Enable a port.
• To enable USB communication on all USB ports, click the Enable toggle button.
• To enable the target USB port on the back of the printer, click the USB Port toggle button.
Note: To use the target USB port on the back of the printer, click both the Enable toggle
button and the USB Port toggle button.
1. To enable Printer Job Language, click the PJL toggle button.
2. Click Print Mode, then select a mode.
3. For Auto Job Timeout, type the amount of time in seconds that the printer waits inactive before
canceling the print job.
4. Click Adobe Communication Protocol, then select a protocol.
5. To enable PostScript
®
Wait Timeout (RAW Mode), click the toggle button.
6. Click OK.
Note: For the new settings to take effect, restart your printer.
34
Xerox
®
VersaLink
®
Series Multifunction and Single Function Printers
System Administrator Guide
Network Connectivity

Xerox VersaLink Series Specifications

General

Brand	Xerox
Model	VersaLink Series
Category	Printer
Language	English