Fax Setup
Xerox WorkCentre 3315DN/3325DN/3325DNI
User Guide
167
5. Press the up/down arrows to highlight the option required and press OK.
6. Press the up/down arrows to highlight the setting required or enter the correct information using
the keypad.
7. Press OK to save the selection.
8. Continue customizing the Sending options as required, then press Stop to return to Ready mode.
Receiving
1. Press Machine Status on the control panel.
2. Press the up/down arrows to highlight Fax Setup and press OK.
3. If necessary, enter the Administrator’s Password using the keypad. Refer to Accessing the Setup
Options on page 154 for instructions.
4. Press the up/down arrows to highlight Receiving and press OK.
The following Receiving options and settings are available:
Note: * indicates the factory default setting.
Image TCR Enables or disables the printing of a transmission
report with a reduced image of the first page of the fax
that was sent.
•On *
•Off
Dial Mode Sets the dialling mode to either tone or pulse.
Note: May not be available in some regions.
• Tone *
• Pulse
Toll Save Sends faxes at a preset toll-saving time to save on call
costs.
•Off *
•On
Option Description Settings
Receive Mode You can select the default fax
receiving mode.
•Fax *
•Tel
•Ans
•Fax
•DRPD
Ring to Answer You can specify the number of
times the machine rings before
answering an incoming call.
• 1 - 7 Times
1 *
Stamp RCV Name This option allows the machine
to automatically print the page
number, and the date and time
of reception at the bottom of
each page of a received fax.
•On
•Off *
Option Description Settings
To Next Page
Loading...
