Xerox WorkCentre 3315DN User Manual

Fax Setup
Xerox WorkCentre 3315DN/3325DN/3325DNI
User Guide
168
Setting up DRPD Mode
To set up the DRPD mode:
1. Press Machine Status on the control panel.
2. Press the up/down arrows to highlight Fax Setup and press OK. If necessary, enter the
Administrator’s Password using the keypad. Refer to Accessing the Setup Options on page 154 for
instructions.
3. Press the up/down arrows to highlight Receiving and press OK.
4. Press the up/down arrows to highlight Receive Mode and press OK.
RCV Start Code This code allows you to initiate
fax reception from an extension
phone plugged into the EXT
socket on the back of the
machine. If you pick up the
extension phone and hear fax
tones, enter the code. It is preset
to *9* at the factory.
• Enter code between 0 - 9
9 *
Auto Reduction When receiving a fax containing
pages longer than the paper
loaded in the paper tray, the
machine can reduce the size of
the image to fit the size of the
paper loaded in the machine.
Note: With this feature set to
Off, the image will be divided
and printed actual size on two or
more pages.
•On *
•Off
Discard Size Discards a specific length from
the end of the received fax.
• 00-30
20 *
Junk Fax Setup Allows numbers that have been
sent to the device to be selected
as junk fax numbers.
•On
•Off *
DRPD Mode Enables a user to use a single
telephone line to answer several
different telephone numbers.
You can set the machine to
recognize different ring patterns
for each number.
•Waiting Ring
2-Sided Print Prints faxes on both sides of the
paper either in a portrait or
landscape orientation.
•Off *
• Flip on Long Edge
• Flip on Short Edge
Local Drive Saving
(3325DN/DNI only)
Stores received faxes in the
common box on the local drive.
•Off *
•On
Option Description Settings

Xerox WorkCentre 3315DN Specifications

General

Brand	Xerox
Model	WorkCentre 3315DN
Category	All in One Printer
Language	English