Xerox WorkCentre 3315DN User Manual

Fax Procedure
Xerox WorkCentre 3315DN/3325DN/3325DNI
User Guide
77
Check the Job Status
1. Press the Job Status button on the control panel
to display job status information.
2. A list of Active Jobs or Saved Jobs is displayed.
Select your job using the up/down arrows and
press OK.
3. The following Job Options are available:
For active jobs:
• Release
•Cancel
For saved jobs:
•Print
• Delete
Stop the Fax Job
Follow the steps below to cancel an active fax job.
1. Press the Stop button on the control panel.
Follow the steps below to cancel a queued fax job.
1. Press the Job Status button on the control panel to display the active jobs.
2. Use the up/down arrows and select the job required, press OK.
3. Select Delete and OK.
4. Select Yes to delete the job or No to return to previous screen.
Fax Confirmation
• When the last page of your original has been sent successfully, the machine beeps and returns to
Ready mode.
• If something goes wrong while sending your fax, an error message appears on the display. For a
list of error messages and their meanings, refer to Fax Problems on page 219. If you receive an
error message, press Stop to clear the message and try to send the fax again.
• You can set your machine to print a confirmation report automatically each time sending a fax is
completed. For further details, refer to Fax Setup on page 166.

Xerox WorkCentre 3315DN Specifications

General

Brand	Xerox
Model	WorkCentre 3315DN
Category	All in One Printer
Language	English