Fax Setup
Xerox WorkCentre 3315DN/3325DN/3325DNI
User Guide
166
Fax Setup
Your machine provides you with various user-selectable options for setting up the fax system. You can
change the default settings for your preferences and needs.
Enable/Disable
Use this option to enable or disable the Fax service:
1. Press Machine Status on the control panel.
2. Press the up/down arrows to highlight Fax Setup and press OK. If necessary, enter the
Administrator’s Password using the keypad. Refer to Accessing the Setup Options on page 154 for
instructions.
3. Press the up/down arrows to highlight Enable/Disable and press OK.
4. Press the up/down arrows to highlight Enabled or Disabled. Press OK.
5. Press Stop to return to Ready mode.
Sending
1. Press Machine Status on the control panel.
2. Press the up/down arrows to highlight Fax Setup and press OK.
3. If necessary, enter the Administrator’s Password using the keypad. Refer to Accessing the Setup
Options on page 154 for instructions.
4. Press the up/down arrows to highlight Sending and press OK.
The following Sending options and settings are available:
Note: * indicates the factory default setting.
Option Description Settings
Redial Times You can specify the number of redial attempts. If you
enter 0, the machine will not redial.
•0 - 13 Times
7 *
Redial Term Your machine can automatically redial a remote fax
machine if it was busy. You can set an interval between
attempts.
•1 - 15 Minutes
3 *
Prefix Dial You can set a prefix of up to five digits. This number
dials before any automatic dial number is started.
• Fax: (enter up to 5
numbers to set the
prefix)
ECM (Error Correction
Mode)
This mode helps with poor line quality and makes sure
any faxes you send are sent smoothly to any other
ECM-equipped fax machine. Sending a fax using ECM
may take more time.
•On *
•Off
Send Report Enables or disables printing of a confirmation report
showing whether the fax was successful or not.
• On Error *
•On
•Off
To Next Page
Loading...
