Page 8-10 Xerox WorkCentre M20i System Administration Guide
Local Connection
Test Print or Scan
To ensure the WorkCentre M20i has been installed correctly a test print or scan should be
submitted from the workstation.
Test Print
Perform the following steps:
¾ Open a document on the workstation.
¾ Select the WorkCentre M20i as the printer to which the document will be sent.
¾ Print the selected document on the device and verify that it prints correctly.
¾ The installation process is now complete.
If the test print fails, refer to the Problem Solving chapter for trouble-shooting procedures.
Test Scan
¾ Open the Twain compliant application used to scan documents.
¾ Place a document in the WorkCentre M20i.
¾ Follow the instructions for scanning from the Help supplied by the application to scan
verify that it scans correctly.
¾ The installation process is now complete.
If the test scan fails, refer to the Problem Solving chapter for trouble-shooting procedures.
1
2
3
4
1
2
3
4
To Next Page
Loading...
