Xerox WorkCentre M20i System Administration Guide Page 3-5
NetWare
Using Xerox CentreWare DP
Installation Procedure
There are four stages required to install the WorkCentre M20i on a NetWare network using
Xerox CentreWare DP:
¾ Network Communication Setup
This procedure will enable the WorkCentre M20i to communicate on the
NetWare network.
¾ Xerox CentreWare DP Setup
This procedure is used to complete the WorkCentre M20i installation using
Xerox CentreWare DP.
¾ Install the printer driver on each workstation (see “Workstation Setup” on page 4-3)
¾ Test Print
A print job should be submitted to ensure the WorkCentre M20i has been
installed and configured correctly.
Network Communication Setup
At the WorkCentre M20i, perform these steps:
HINT: Xerox CentreWare Internet Services can also be used to configure the
WorkCentre M20i, refer to the Internet Services chapter for instructions.
¾ Ensure that the Basic TCP/IP settings have been configured (see “Network
Communication Setup” on page 2-8).
¾ Press the [Machine Status] button.
¾
1
2
3
¾ Press or until System
Admin Tools is displayed and
press [Enter].
¾ If the System Admin Tools have
been passcode protected, type in
the password and press [Enter].
System Admin Tools
[Passcode Protect]
To Next Page
Loading...
