Xerox WorkCentre M20i - Passcode Protection; Enable Passcode Protection

Xerox WorkCentre M20i System Administration Guide Page 11-9
Administration Tools
Passcode Protection
System Administration functions can be restricted to individual users by requiring that a
passcode be entered before access to the functions can be granted.
Enable Passcode Protection
To enable passcode protection:
¾ Press the [Machine Status] button.
NOTE: When the machine is first installed, the passcode is blank. When you
choose Yes, you will be asked to enter the passcode. Simply press [Enter] when
requested to enter the passcode.
¾ If you Enabled passcode protection, continue with Change the Passcode to enter the new
passcode.
1
2
¾ Press or until System
Admin Tools is displayed and
press [Enter].
¾ If the System Admin Tools has
already been passcode
protected, type in the password
and press [Enter].
System Admin Tools
[Passcode Protect]
3
¾ Press or until Passcode
Protect is displayed and press
[Enter].
¾ To enable passcode protection,
press or until Yes is
displayed and press [Enter].
Otherwise display No and press
[Enter] to disable passcode
protection.
Passcode Protect
[Yes]
4