Page 4-14 Xerox WorkCentre M20i System Administration Guide
Print Driver Installation for Networked Printers
Test Print
To ensure the WorkCentre M20i has been installed on the network correctly a test print should
be submitted from a client workstation. Perform the following steps:
¾ Open a document on a client workstation.
¾ Select the WorkCentre M20i as the printer for sending documents to.
¾ Print the document on the device and verify that it prints correctly.
¾ Ensure the print driver is installed on every workstation that will be sending jobs to the
device.
¾ Repeat the test for all workstations that will be sending jobs to the device.
If the test print fails, refer to the Problem Solving chapter for trouble-shooting procedures.
1
2
3
4
5
To Next Page
Loading...
