Page 11-24 Xerox WorkCentre M20i System Administration Guide
Administration Tools
Checking Configurations
Use these instructions to check the configuration settings of the WorkCentre M20i.
To check the configuration, perform these steps:
¾ Enable CentreWare Internet Services (see “Enabling Internet Services” on page 11-20).
¾ At the CentreWare Internet Services Home Page for the WorkCentre M20i, select the
[Properties] tab.
¾ Select the plus symbol [+] to the left of the General Setup folder in the Properties frame.
¾ In the Properties frame, within the General Setup folder, select [Configuration].
The lower pane will show the firmware versions.
Click [Print System Data List] to print this report.
¾ In the upper pane, click the link for the settings that you want to check.
1
2
3
4
5
To Next Page
Loading...
