Xerox WorkCentre M20i - LDAP Directory

Xerox WorkCentre M20i System Administration Guide Page 9-21
Scan to Email
LDAP Directory
Use these instructions to configure the Light Weight Directory Access Protocol (LDAP) using
CentreWare Internet Services.
Configure LDAP
To configure LDAP, perform these steps:
¾ Enable CentreWare Internet Services (see “Enabling Internet Services” on page 9-20).
¾ At the CentreWare Internet Services Home Page for the WorkCentre M20i, select the
[Properties] tab.
¾ Select the plus symbol [+] to the left of the Connectivity folder in the Properties frame,
and then select the [+] symbol to the left of the Protocols folder.
¾ Select [LDAP Directory] and check the details are correct. If any of the details are
incorrect then enter the correct information.
¾ In the Server Information area identify where the directory will be found:
Choose whether to use the [IP address] or [Host Name].
Enter the appropriate information.
¾ In the Optional Information area identify where the directory will be found:
Enter the required information Information.
¾ Click the [Apply] button to implement any changes.
NOTE: Click the [Undo] button to cancel any changes made and return to the
previous values.
1
2
3
4
5
6
7