Xerox WorkCentre M20i - New Drum

Xerox WorkCentre M20i System Administration Guide Page 11-17
Administration Tools
New Drum
This function is used to reset the drum counter after a drum has been replaced.
To set the new drum:
¾ Press the [Machine Status] button.
1
2
¾ Press or until System
Admin Tools is displayed and
press [Enter].
¾ If the System Admin Tools has
already been passcode
protected, type in the password
and press [Enter].
System Admin Tools
[Passcode Protect]
3
¾ Press or until New
Drum is displayed and press
[Enter].
¾ To set drum counter to zero,
press or until On is
displayed and press [Enter].
Otherwise display Off and press
[Enter] to exit the selection.
New Drum
[On]