Page 9-4 Xerox WorkCentre M20i System Administration Guide
Scan to Email
Configuring SMTP
This section describes how to configure the Simple Mail Transfer Protocol used by the
WorkCentre M20i for scan to Email. The settings are:
¾ SMTP IP Address - see page 9-5.
¾ Maximum Mail Size - see page 9-6.
¾ User Authentication - see page 9-7.
NOTE: All configurations for SMTP can be setup using CentreWare Internet
Services but not all settings can be setup at the machine. Refer to “Email Setup
using Internet Services” on page 9-20.
To Next Page
Loading...
