Xerox WorkCentre M20i - Changing the Master Code

Xerox WorkCentre M20i System Administration Guide Page 11-7
Administration Tools
Changing the Master Code
To change the Master Code:
¾ Press the [Machine Status] button.
1
2
¾ Press or until System
Admin Tools is displayed and
press [Enter].
¾ If the System Admin Tools has
already been passcode
protected, type in the password
and press [Enter].
System Admin Tools
[Passcode Protect]
3
¾ Press or until
Department is displayed and
press [Enter].
¾ Enter the master access code.
NOTE: The first time that you
access departments, you will be
prompted to enter a master
access code then re-enter it to
confirm the code.
System Admin Tools
[Department]
4
¾ Press or until Change
M. Code is displayed and press
[Enter].
Department
[Change M Code]