Xerox WorkCentre M20i - Page 30

Page 2-4 Xerox WorkCentre M20i System Administration Guide
Basic Network Installation
¾ Setup the TCP/IP addresses (see “Basic TCP/IP Settings” on page 2-5).
5
¾ Press or until Configure
Network is displayed and press
[Enter].
¾ Press or until Ethernet
is displayed and press [Enter].
Config. Network
[Ethernet]
6
¾ Press [Enter] to set the speed.
Ethernet
[Speed]
7
¾ Press or to display the
appropriate speed and press
[Enter].
The choices are:
Auto
10M Half
10M Full
100M Half
100M Full
Speed
[Auto]
8