Xerox WorkCentre M20i - Page 82

Page 6-4 Xerox WorkCentre M20i System Administration Guide
Advanced TCP/IP Setup
NOTE: While you can change the port number at which the WorkCentre M20i will
accept LPR print jobs, it is recommended that you do this ONLY with extreme
caution as most LPR spoolers are set to send print jobs to the default port number,
515.
66
¾ Press or until TCP/IP is
displayed and press [Enter].
Config Network
[TCP/IP]
7
¾ Press or until Manual is
displayed and press [Enter].
TCP/IP
[Manual]
8
¾ Press or until LPD/LPD
is displayed and press [Enter].
Manual
[LPD/LPD]
9
¾ To enable or disable LPD/LPD,
press or until the
desired setting, [Enable] or
[Disable] is displayed, enter the
port number using the keyboard
and press [Enter].
LPD/LPD
[Enable]