Page 7-10 Xerox WorkCentre M20i System Administration Guide
Network Installation Using Internet Services
Test Print
To ensure the device has been installed on the network correctly a test print should be
submitted from a client workstation. Perform the following steps:
¾ Open a document on a client workstation.
¾ Select the WorkCentre M20i in the Chooser as the printer to which the selected document
will be sent.
¾ Print the document on the device and verify that it prints correctly.
¾ Ensure the driver is installed on every workstation that will be sending jobs to the
WorkCentre M20i.
¾ Repeat the test for all workstations that will be sending jobs to the WorkCentre M20i.
¾ The installation process is now complete.
If the test print fails, refer to the Problem Solving chapter for trouble-shooting procedures.
1
2
3
4
5
6
To Next Page
Loading...
