Xerox WORKCENTRE PE 220 - Page 129

General Procedures and Information
Workcentre PE 220 11/05 6-21
Scanner
600dpi Color CIS Module for Flat bed, uses the CIS scanning method
1) CIS SPEC
- Scanning size: 216 mm (width for letter-size)
- Light source: LED
- Scanning sensor: CIS 600/300 dpi
- Scanning mode: Color SCAN / Mono SCAN
- MTF: 30% (300 dpi Chart)
- CIS interface: Analog output
- Power supply: 3.3V
- Clock Frequency: 5MHz max.
- Number of output: 1
- LED Current: Red/Green/Blue: 60mA
- Clamp Level: 1.1V
- Connection: 12 pin FFC connector (pitch 1.0mm)
2) Scan Resolution
(a) Transmission
- Normal: Vertical: 3.85 Line/mm, Horizontal: 8 Pels/mm:203 x 98dpi
- Fine: Vertical: 7.7 Line/mm, Horizontal: 8 Pels/mm:203 x 196dpi
- Super Fine: Vertical: 11.8 Line/mm, Horizontal: 11.8 Pels/mm ;300 x 300dpi
(b) When Copy: Vertical: 11.8 Line/mm, Horizontal: 23.6 Pels/mm :600x300dpi(ADF)
Vertical: 23.6 Line/mm, Horizontal: 23.6 Pels/mm :600x600dpi(Platen)
3) Half Tone (Gray Scale): 256 Levels
4) Scan Line Time
(a) Tx
- Normal: 1.5 ms/Line
- Fine: 1.5 ms/Line
- Super Fine: 1.5 ms/Line
(b) Copy: 1.5 ms/Line
(c) Scan
- Color: 4.5msec/line
- Gray: 4.5msec/line
- Mono: 4.5msec/line
5) Scanning Width
- MAX SCAN WIDTH: 216 mm (8.5 inches)
- Effective Scan Width: 208mm (8.19 inches)
6) ADF Motor
(a) Motor Spec
- 24VDC
- 0.6A(Peak)