Xerox WORKCENTRE PE 220 User Manual

General Procedures and Information
Workcentre PE 220 11/05 6-41
GP 6 LCD Status Error Messages
Table 1:
STATUS LCD Display Descriptions
Document Jam Document Jam When Document Jam occurred at ADF module.
Door Open or Jam
Cover Open
[Front or Rear]
[Cover Open]
When machine’ front side cover or Jam Cover was
opened.
NO paper [No Paper]
Add Paper
When there is no paper in CASSETTE Tray.
PAPER JAM 0 [Paper Jam 0]
Open/Close Door
When the machine encountered paper jam in pick up
area, Machine displays on the LCD until DOOR OPEN &
CLOSE.
PAPER JAM 1 [Paper Jam 1]
Open/Close Door
When the machine encountered paper jam in paper exit
of Machine, machine displays on the LCD until DOOR
OPEN & CLOSE.
PAPER JAM 2 [Paper Jam 2]
Check Inside
When the machine encountered paper jam in paper exit
of Machine, machine displays on the LCD until DOOR
OPEN & CLOSE.
Communication Error [COMM. Error] When the machine has a problem in communication.
Machine displays this in case of Transmission.
Machine displays this in case of fax handshaking step of
Reception.
Line Error [Line Error] When the machine has problem in case of Fax Data
reception step.
NO ANSWER [No Answer] When the machine could not connect to remote fax after
Completion of redial up to redial counter in system data.
INCOMPATIBLE [Incompatible] Remote party did not have the requested feature, such
as polling.
LINE BUSY Line Busy The remote fax did not answer.
POWER FAILURE Power Failure When the machine user memory has not been backed
up and there was power off / on.
STOP PRESSED [Stop Pressed] When the operator pressed the STOP key during trans-
mission.
MEMORY FULL Memory Full When the machine has encountered the user memory
was full,
FUSER ERROR CRU Fuse Error When the machine failed in installing the new print car-
tridge.
LSU ERROR [Hsync Error] Tech mode
LSU ERROR [LSU Error] User mode
The LSU does not reach the READY state,
TONER LOW [Toner Low] The machine has encountered the Toner Low,
TONER EMPTY [Toner Empty] The machine has encountered the Toner Empty,
BYPASS JAM [Bypass Jam] The machine detected the non feeding from BYPASS
Tray.
GROUP is not available Group Not Available You have tried to select a group location where only a
single Location number can be used.
RETRY REDIAL? Retry Redial? The machine is waiting for the programmed interval to
automatically redial a previously busy station.
NO. NOT ASSIGNED NO. Not Assigned The speed dial location you tried to use has no number
assigned to it.

Xerox WORKCENTRE PE 220 Specifications

General

Brand	Xerox
Model	WORKCENTRE PE 220
Category	All in One Printer
Language	English