XIMEA xiC - Page 113

xiC - Technical Manual Version 1.16
113
figure 3-43, position GPIO connector 51
figure 3-44, pinning GPIO connector 51
figure 3-45, digital input, interface schematic 53
figure 3-46, digital input, interface wiring 53
figure 3-47, digital output, interface schematic 55
figure 3-48, digital output transfer characteristics 55
figure 3-49, Connecting Digital OUTPUT to a NPN-compatible PLC device input (biased) 56
figure 3-50, Connecting Digital OUTPUT to a NPN-compatible PLC device input - more bidirectional inputs used 56
figure 3-51, Connecting Digital OUTPUT to a NPN-compatible PLC device - single input 56
figure 3-52, Connecting Digital OUTPUT to a PNP-compatible device 57
figure 3-53, LED Driving 58
figure 3-54, Inductive load (Relay) Driving (inverted logic) 59
figure 3-55, Inductive load (Relay) Driving (non-inverted logic) 59
figure 3-56, non isolated input/output, interface schematic 61
figure 3-57, drawing USB3 cable 63
figure 3-58, wiring USB3 cable 63
figure 3-59, label details USB3 cable 63
figure 3-60, drawing USB3 cable angled 64
figure 3-61, wiring USB3 cable angled 64
figure 3-62, label details USB3 cable angled 64
figure 3-63, flex cable 65
figure 3-64, flex cable ends 65
figure 3-65, drawing USB3 cable 65
figure 3-66, IO/AUX cable pin numbering 66
figure 3-67, mounting tripod adapter 67
figure 3-68, dimensional drawing tripod adapter 67
figure 3-69, USB3 host adapters 68
figure 4-1, Saturation vs Sensor output for different digitization bit depths 73
figure 4-2, Saturation vs Sensor output for different digitization bit depths 2
nd
generation IMX sensors 73
figure 4-3, acquisition mode - free run 74
figure 4-4, acquisition mode – triggered with overlap 75
figure 4-5, triggered burst of frames – frame burst start, number of frames in burst set to 3 76
figure 4-6, triggered burst of frames – frame burst active 76
figure 4-7, Exposure defined by trigger pulse length 76
figure 4-8, Multiple exposures - defined exposure time, number of exposures set to 5 77
figure 4-9, Multiple exposures - exposure time defined by trigger pulse length, number of exposures set to 5 77
figure 5-1, CamTool Layout 81
figure 5-2, XIMEA Windows Software Package installation - 1 84
figure 5-3, XIMEA Windows Software Package installation - 2 85
figure 5-4, XIMEA Windows Software Package installation - 3 85
figure 5-5, xiAPI installation, Windows - 4 86
figure 5-6, xiAPI installation, Windows - 5 86
figure 5-7, XIMEA Linux Software Package installation - 1 87
figure 5-8, XIMEA Linux Software Package installation - 2 88