Xinje VH6 Series - Page 57

51
Group P0: Basic operation parameters
Parameter
Name
Setting range
Default
value
Modify
Modbus
address
P0-05
Frequency source
superposition selection
Ones bit: Frequency source selection
0: Main frequency source A
1: Calculation results of main and auxiliary
frequency sources
2: Switching between main frequency source A
and auxiliary frequency source B
Tens bit: the operation relationship of main and
auxiliary frequency sources
0: A+B
1: A-B
2: max (A, B)
3: min (A, B)
00
○
0005H
P0-06
Auxiliary frequency source B
range selection
0: Relative to the maximum frequency
1: Relative to the main frequency source A
0
○
0006H
P0-07
Auxiliary frequency source B
range
0%~150%
100%
○
0007H
P0-09
Digital setting of auxiliary
frequency source offset
0.00Hz~max frequency P0-13
0.00Hz
○
0009H
P0-10
Preset frequency
0.00Hz~max frequency P0-13
50Hz
○
000AH
P0-12
Frequency shutdown memory
selection for digital setting
0: No memory
1: Memory
0
○
000CH
P0-13
Maximum output frequency
50.00Hz~600.00Hz
50.00Hz
×
000DH
P0-14
Upper limit frequency source
0: Set by P0-15
1: AI1 setting
2: AI2 setting
3: AI3 setting
4: Pulse setting
5: Communication setting
0
×
000EH
P0-15
Upper limit frequency
Lower limit frequency P0-17~Max output
frequency P0-13
50.00Hz
○
000FH
P0-16
Upper limit frequency offset
0.00Hz~ Max output frequency (P0-13)
0.00Hz
○
0010H
P0-17
Lower limit frequency
0.00Hz~ Upper limit frequency P0-15
0.00Hz
○
0011H
P0-18
Acceleration time 1
0~65000s (PC-09=0)
0.0~6500.0s (PC-09=1)
0.00~650.00s (PC-09=2)
Model
setting
○
0012H
P0-19
Deceleration time 1
0~65000s (PC-09=0)
0.0~6500.0s (PC-09=1)
0.00~650.00s (PC-09=2)
Model
setting
○
0013H
P0-20
Operation direction
Ones bit: running direction
0: Run in the default direction
1: Run in the opposite direction to the default
direction
Tens bit: Reverse inhibit (supported by 3720
0
○
0014H