Xinje VH6 Series - Group U0 Monitor Parameters

169
4-2-23. Group U0 Monitor parameters
Parameter
Name
Min unit
U0-00
Operation frequency (Hz)
0.01Hz
U0-01
Setting frequency (Hz)
0.01Hz
U0-02
Bus voltage (V)
0.1V
U0-03
Output current (A)
0.01A
U0-04
Output voltage (V)
1V
U0-05
Output torque (%) Percentage output value of motor rated torque
0.1%
U0-06
Output power (kW)
0.1kW
Parameter
Name
Min unit
U0-07
X input state
1
Displays the current X terminal input status value. DX corresponds to the virtual X terminal state. After
hexadecimal conversion to binary data, each bit corresponds to an X input signal. 1 indicates that the input is a
high-level signal, and 0 indicates that the input is a low-level signal. The corresponding relationship between
each bit and input terminal is as follows:
Parameter
Name
Min unit
U0-08
Y output state
1
Displays the current Y terminal output status value. After hexadecimal conversion to binary data, each bit
corresponds to an output signal. 1 indicates that the input is a high-level signal, and 0 indicates that the input is
a low-level signal. The corresponding relationship between each bit and input terminal is as follows: