Xinje VH6 Series - Group PB: Multi-Speed and Simple PLC Operation Parameters

72
Group PA: Process control closed-loop parameters
Parameter
Name
Setting range
Default
value
Modify
Modbus
address
condition
1: Switch through X terminal
2: Switch automatically according to
deviation
3: Switch automatically according to the
operation frequency
PA-14
PID parameter switching
deviation 1
0.0%~PA-15
20.0%
○
0A0EH
PA-15
PID parameter switching
deviation 2
PA-14~100.0%
80.0%
○
0A0FH
PA-16
PID proportional gain P2
0.0~100.0
20.0
○
0A10H
PA-17
PID integral time I2
0.01s~10.00s
2.00s
○
0A11H
PA-18
PID differential time D2
0.000s~10.000s
0.000s
○
0A12H
PA-19
PID action direction
0: Positive action
1: Negative action
0
○
0A13H
PA-20
PID given feedback range
0~65535
1000
○
0A14H
PA-21
PID maximum deviation
between two outputs
0.00%~100.00%
1.00%
○
0A15H
PA-22
PID minimum deviation
between two outputs
0.00%~100.00%
1.00%
○
0A16H
PA-23
PID initial value
0.0%~100.0%
0.0%
○
0A17H
PA-24
PID initial value holding time
0.00s~600.00s
0.00s
○
0A18H
PA-25
PID operation mode (whether
to operate when stop)
0: Not operation when stop
1: Operation during shutdown
0
○
0A19H
PA-26
PID integral attribute
Ones bit: Integral separation
0: Invalid
1: Valid
Tens bit: Whether to stop integration
after output to limit value
0: Continue to integral
1: Stop integral
00
○
0A1AH
PA-27
PID feedback lost detection
value
0.0%: not judge the feedback lost
0.1%~100.0%
0.0%
○
0A1BH
PA-28
PID feedback lost detection
time
0.0s~30.0s
0.0s
○
0A1CH
Group PB: Multi-speed and simple PLC operation parameters
Group PB: multi-speed and simple PLC operation parameters
Parameter
Name
Setting range
Default
value
Modify
Modbus
address
PB-00
Multi-segment frequency 0
-100.0%~+100.0%
0.0%
○
0B00H
PB-01
Multi-segment frequency 1
-100.0%~+100.0%
0.0%
○
0B01H