76
Group PC: auxiliary operation parameters
Frequency reached detection
value 2
0.00Hz~ max output frequency
Frequency reached detection 2
range
0.0%~100.0% (max output
frequency)
Timing function selection
Present operation reached time
Setting power on reached time
Setting operation reached time
Current reached detection value 1
0.0%~300.0% (motor rated
current)
Current reached detection 1
range
0.0%~300.0% (motor rated
current)
Current reached detection value 2
0.0%~300.0% (motor rated
current)
Current reached detection 2
range
0.0%~300.0% (motor rated
current)
Zero current detection value
0.0%~300.0% (motor rated
current)
Zero current detection delay time
Software overcurrent point
0：0.0% (not detect)
1 ： 0.1%~300.0% (motor rated
current)
Software overcurrent detection
delay time
AI1 input voltage lower limit
AI1 input voltage upper limit
Operation action when the
frequency is lower than lower
limit frequency
0: Run at lower limit frequency
1: Stop
2: Run at zero speed
Module temperature reached
0: The fan runs during operation
1: The fan is running all the time
Terminal jog run priority
SVC optimization selection
1: Optimization mode 1
2: Optimization mode 2
Dead area compensation mode
To Next Page
Loading...