Yaesu FT1DR - Recalling Preset Receiver Memory Channel to Listen to the International VHF (Marine) Radio

52
Using the Memory
Convenient Preset Receiver Memory Channels
Recalling Preset Receiver Memory Channel to Listen to the
International VHF (Marine) Radio
The frequencies (57 channels) used for the international VHF (marine) radio are
registered to the dedicated preset receiver memory channels.
1 Press A to set A-band to the operating band.
2 Press F and then 3 to enter the Preset Receiver mode.
3 Press B.
Select [SP2 INTVHF].
4 Turn O to select a preset VHF receiver memory channel
to listen to.
Remark To stop reception of the international VHF radio, press
3.
In the event of extreme weather disturbances, such as storms and hurricanes, the
NOAA (National Oceanic and Atmospheric Administration) sends a weather alert
accompanied by a 1050 Hz tone and subsequent weather report on one of the NOAA
weather channels. You may enable the Weather Alert tone via Set Mode option
[4 SIGNALING]  [14 WX ALERT], if desired (See page 122).
Tips
• The preset receiver memory channel cannot be rewritten with the data of another frequency.
• To scan the preset receiver memory channels toward higher channel numbers, press F and then
2.
Turning O one click counterclockwise scans the preset receiver memory channels toward lower
channel numbers. If a signal is received during scanning, the scanning is suspended for 5 seconds.
• The operation that is performed when scanning stops can be set by following the procedure
described in “Selecting a Reception Method When Scanning Stops” on page 59.
WX Channel Frequency List
CH Frequency CH Frequency
1 162.550 MHz 6 162.500 MHz
2 162.400 MHz 7 162.525 MHz
3 162.475 MHz 8 161.650 MHz
4 162.425 MHz 9 161.775 MHz
5 162.450 MHz 10 163.275 MHz
䎬䎱䎷䎬䎱䎷䎃 䎹䎫䎩
FT1DRDEEng.indb52FT1DRDEEng.indb52 13/06/2815:1613/06/2815:16