7-13
1
2
3
4
5
6
7
8
9
10
SPECIFICATIONS
WIRE ROUTING DIAGRAM
1. Spark plug cap 5. Engine switch lead (ground)
2. TCI unit lead 6. Wire harness protector
3. Oil level switch lead 7. Oil warning unit
4. Engine switch
A. The spark plug cap should face the direction indicated in the illustration.
B. Route the lead as shown.
C. The lead is black and the protector is gray.
D. Make sure that the gap between the end of the wire harness protector and end of the crankcase is 20
mm (0.79 in) or more.
E. Fasten the ground terminal and engine switch together.
F. Screw in the high tension cord until it touches the spark plug cap.
To Next Page
Loading...
